Connecting S0 to WiFi

Since S0 is based on ESP32C6 which has WiFi capabilities, it can be configured in Station Mode or Access Point Mode.

Ensure you are in the embedded/targets/zephyr/m0-wifi directory

Access Point Mode

To configure the S0 as an access point, configure the parameters in src/config.h to your preference.

Set parameters like WIFI_AP_SSID and WIFI_AP_PSK to your preference. An example being:

/* AP Mode Configuration */
#define WIFI_AP_SSID       "M0-AP"
#define WIFI_AP_PSK        ""
#define WIFI_AP_IP_ADDRESS "192.168.4.1"
#define WIFI_AP_NETMASK    "255.255.255.0"

Station Mode

To configure S0 in station mode, configure the WiFi ssid and password as shown in src/config.h

/* STA Mode Configuration */
#define WIFI_SSID "SSID"     /* Replace `SSID` with WiFi ssid. */
#define WIFI_PSK  "PASSWORD" /* Replace `PASSWORD` with Router password. */

Bulding and Flashing Code

Build the code and upload it to S0:

west build -p always -b esp32c6_devkitc
west flash
west espressif monitor

See the logs from the Serial Monitor to check whether S0 is connected.